Filter
Top Products
4
Connecting the Mouse Receiver
To connect the mouse receiver:
1 Turn off your computer.
2 Plug the standard USB end of the cable into an available USB
port on your computer.
You are now ready to install the device drivers for your operating
system.
Installing the Device Drivers
NOTE: You must install the supplied device drivers to use the
fourth and fifth buttons. Otherwise, the mouse will function as
a standard, three-button mouse.
To install the supplied device driver:
1 Turn on your computer.
2 Insert the driver software CD into your computer’s CD-ROM
drive.
3Click Start, Run, then enter D:\Setup.exe (where D: is the path
of your CD-ROM drive) and then click OK.
The Welcome screen appears.
4Click Next.
5Select Typical or Custom installation and then click Next.
6Click Yes.
7Click Finish to complete the driver installation and restart your
computer.
Once your computer restarts, the mouse icon appears in the
system tray.
You are now ready to install the battery in the mouse, set the
radio frequency channel, and establish a communications link
between the mouse and its receiver. See “Establishing a
Communications Link” on page 6.