Filter
Top Products
5
Using the RF Mouse
Installing the Battery
1 Remove the battery cover from the bottom of the mouse by
pressing the battery cover tab and siding it off.
2 Insert the supplied battery, making sure that the positive (+)
and negative (-) end of the battery match the polarity indicators
inside the battery housing.
3 Slide the battery cover back into position until it “clicks”
firmly into place.
The optical sensor, located on the bottom of the mouse, glows
red.
WARNINGS: When replacing the battery, if you are using the
mouse with the charger base, you must use heavy-duty NiMH
rechargeable batteries to avoid possible damage to the mouse
and charger.
If you are using the mouse without the charger base, you may
use alkaline or other heavy-duty NiMH batteries.
Setting the Radio Frequency Channel
Before you establish a link between the optical mouse and its
receiver, you must set the radio frequency channel. To do this,
slide the channel switch to A or B on both the mouse and the
receiver. For the mouse, the switch is located inside the battery
compartment. For the receiver, the switch is located directly
opposite the USB connector.
NOTE: The optical mouse and its receiver must be set to the
same channel to function properly.