Filter
Top Products
18
EN
Using the Teletext
Alarm page
In some countries (Spain, Benelux, etc.), you can set a time to display
certain Teletext pages (alarm pages).
To do this, display the relevant alarm page and press the
and
buttons to enter subpage mode. Enter the time instead of the subpage
number (e.g. 1705 for 17:05) and press exit. The page will disappear
and will appear again at the set time, as long as you do not change
channels or switch off the set beforehand.
Fastext
If Fastext is available, direct access to previous and subsequent pages
is replaced with coloured bars (red, green, yellow and blue) which
provide links to the topics you can access by pressing the correspond-
ing buttons on the remote control.
Press the menu button to access these direct links, press it again to
display the navigation bar.
Temporary change of the character set
You can temporarily change the character set. To do so, display the
navigation bar using the menu button, then press the ok button to
display the number of the current character set in place of ???.
Scroll the list of character sets using the green button. Press the ok
button to display the ??? function again.
The character set will reset to the one selected in the MANUAL IN-
STALLATION menu:
– when the set is turned off or put into standby,
– when you change channels.
In Teletext mode, volume controls remain available, but the relevant
symbols do not display.
Subtitles
Some channels provide subtitles for some of their programmes through
Teletext. The numbers of the relevant pages are specified on the
Teletext index page.
To display the subtitles, enter the number of the relevant page. Once it
is found, the subtitles appear in the TV picture. The header and the
navigation bar disappear after a couple of seconds. To display them
again, press any button (except exit, the
button or the volume
adjustment buttons) on the remote control.
To return to TV mode, press exit.
42WM03STW-0707-en.p65 2003/9/5, PM 12:5318