Filter
Top Products
27
E-DOC-CTC-20051017-0147 v2.0
Chapter 2
Local Network Setup
To configure WDS Proceed as follows:
1 Go to the SpeedTouch™ Web pages.
2 In the menu, select Home Network.
3 Click your WLAN.
4 In the upper right corner, click Configure.
5 On the Wireless Access Point page, in the Pick a task list, click Configure WDS.
6 Select WDS Enabled.
7 In the Pick a task list, click Scan for wireless access points.
A warning is displayed.
8 Click OK.
The SpeedTouch™ scans for access points on the same radio channel.
9 Select your repeater in the List of Accessible Access Points, and then click
Apply.
If not already done, set a fixed channel and check whether the security
settings (WEP encryption or no encryption) on your SpeedTouch™ are
the same as on the repeater.