Filter
Top Products
ENGLISH - 11
Preparation
About Your Projector
Remote control
NOTE:
• Do not drop the remote control.
• Avoid contact with liquids or moisture.
• Use manganese batteries or alkaline batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• Do not point the laser in other people’s eyes or stare into beam.
• See “Remote control operation” on page 22.
Switch to cycle through
the input method.
(page 23)
Display the LENS
CONTROL menu and
adjust the focus and size
of the image. (page 25)
Turn off the power
automatically by setting
the duration. (page 25)
Switch to cycle through
the aspect ratio.
(page 23)
Switch to cycle through
the PICTURE MODE.
(page 25)
Display the MEMORY
LOAD menu. (page 23)
Display the input
waveform. (page 24)
Display the PICTURE
menu. (page 25)
Display the COLOUR
MANAGEMENT menu.
(page 26)
Remote control signal emitter
Remote control signal. (page 22)
Turn the button backlight
of the remote control on/
off. (page 22)
Function buttons
Assign the frequently used functions
from the options for shortcut. (page 39)
Learning remote control buttons and
LCD
Programme and operate other devices.
See “Remote Control Operating Guide”
which is provided with the projector.
Return to the previous menu.
(page 30)
Capture the projected
image as a still image.
(page 22)
POWER button
While the MAIN POWER
button is on, switch between
stand-by mode and projection
mode. (page 19)
Display the main menu or
return to the previous menu.
(page 30)
Navigate through the
menus with FGIH,
and activate the menu
item with ENTER.
(page 30)
Reset some of the settings
to the factory default
settings. (page 22)
Battery compartment
1. Press the tab and lift up the cover.
2. Insert the batteries according to the
polarity diagram indicated inside.