Filter
Top Products
Preparation
About Your Projector
ENGLISH - 13
J Back and bottom view
NOTE:
• Do not cover the ventilation openings or place anything within 50 cm (20") of them as this may cause damage or injury.
• The projector should only be used with the attached mains lead to ensure optimum performance and avoid damage to the
projector.
• Do not open the top cover other than replacing the lamp unit.
Connecting
terminals
(page 18)
Air intake port
Security lock
Attach the commercial shackle lock
which is provided with the projector.
Compatible with the Kensington
MicroSaver Security System.
(page 51)
Top cover
Hold at the back corner of the top
cover and slightly push up to open.
(page 44)
Air intake port
AC IN
Connect the mains lead to
supply electronic power to the
projector. (page 19)
Safety cable attachment point
Attach the safety cable when
mounted in the ceiling.
(page 51)
COMPUTER IN
Connect an RGB signal cable
from your PC.
S-VIDEO IN
Connect a S-VIDEO
signal cable.
VIDEO IN
Connect an RCA
composite video cable.
COMPONENT IN
Connect YPBPR signal cables.
Lens cover attachment holeFront leg adjusters
Screw up/down to adjust the
projection angle. (page 15)
Front leg adjusters
Screw up/down to adjust the
projection angle. (page 15)
SERIAL
Connect a compatible cable for
controlling the projector
remotely via your computer.
(page 48)
HDMI IN
Connect HDMI signal cables.