Filter
Top Products
38
E-DOC-CTC-20051017-0152 v1.0
Chapter 4
Voice over IP
4.1 Telephony Setup
Telephony installation The SpeedTouch™ is equipped to connect one or two analogue phones or faxes.
Use a phone cable with RJ-11 connectors to:
1 Wire the SpeedTouch™ Phone port(s) to your phone(s) or fax.
2 If your SpeedTouch has a black-coloured port labeled "PSTN", you must
connect this port to the telephone output of your DSL splitter to allow regular
phone calls with the same telephone set. In the other case, no additional
connections are needed.
Telephony configuration The telephony service might already have been configured on your SpeedTouch™
during initial setup.
If not, follow the instructions below:
Enable the telephony service
Configure the telephony service
This is only required if you still want to make phone calls using the
regular telephone line.
!
Be aware that, if the PSTN port (if provided) is not wired to your
telephone wall outlet or distributed filter, emergency calls are not
always possible!
!
As distributed filters are country-specific, you cannot use the device
everywhere.
2
1
ETHERNET
12
DSL PSTN PHONE RESETUSB