Filter
Top Products
TMTM
Y
N
Edge detection
sensor
Ottobot loves to play and has an array of buttons and sensors
that allow him to interact and respond to you. Activating any of
these sensors will start Ottobot and he will respond and invite
you to play. Following is a detailed list of Ottobot’s features and
where they are located.
Light-up
control panel
Orientation sensor
(Tilt and invert sensors)
Light sensor
Object detection
&
IR communication
Sound
sensor
Left & right
hand sensor
Battery
compartments
Battery Installation
Ottobot can’t wait to be your friend, but before you
can play with him, he will first need batteries.
Please follow these simple steps:
1. Ask an adult to help install batteries.
2. Slide the power switch to off position first.
3. Turn Ottobot upside down and open the
2 battery compartments on each foot by
loosening the screws. Place the covers
be aside and be careful not to misplace them.
4. Insert four (4)”AA or LR6” batteries (not
included) into the battery compartments, two (2)
into each foot. Be careful to follow the correct battery
positions. Replace the covers and tighten the screws.
Battery installation should be done by an adult.
5. Slide the power switch to on position and Ottobot will wake
up and be ready to play.
To ensure proper function :
- Do not mix old and new batteries.
- Do not mix alkaline, standard or rechargeable batteries.
- Battery installation should be done by an adult.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the toy before being charged (if
removable).
- Rechargeable batteries are only to be charged under adult supervision (if removable).
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Do not dispose of batteries in fire, batteries may explode or leak.