Toshiba 203SD Copier User Manual


 
MAKING COPIES
22
3
Place the original(s) face up in the
document feeder tray without trying
to force them in.
The RADF indicator on the operation panel
will light up. If this indicator does not light up,
the originals are not properly set or the RADF
is not properly closed.
4
Select the number of copies and any other copy settings, and
then press the [START] key ( ).
Originals that cannot be used in the RADF
The following originals cannot be used. These may cause misfeeds or smudging and
unclear images.
Transparencies, tracing paper, other transparent or translucent paper, and
photographs.
Carbon paper, thermal paper.
Originals that are creased, folded, or torn.
Glued originals, cut-out originals.
Originals with binder holes.
Originals printed using an ink ribbon (thermal transfer printing), originals on
thermal transfer paper.
Original output tray extension
When placing an original larger than 8-1/2" x 11" size, pull out the original output tray
extension of the RADF.
Capacity of paper output tray
The default output mode for copying from the RADF is sort mode
(P.29), and a checkmark " " will automatically appear in the display
(P.11). If "SORT AUTO SELECT" is disabled in the user programs,
the default output mode will be non-sort mode. (P.57)
To stop copying in the middle of a run, press the [CLEAR] key ( ).
For the copy settings, see pages 23 through 35.
Original face up
Note
The paper output tray can hold a
maximum of 200 pages. If more
than 200 pages are allowed to
accumulate, a paper jam may occur.