Filter
Top Products
38 AS/400 Print Solution — Installation
Step 3: Starting up auto assign (resident) program
This section describes how to start up auto assign (resident) program.
NOTE:
• It is recommended to load the auto assign (resident) program into IPL.
1. Login as a user with QSECOFR authority.
2. Execute the command below to add a library "WTEC02" to
the top of the library list.
ADDLIBLE WTEC02
3. Execute a command [STRTECPRT] + [F4]. Then select the
name of OUTQ that you specified at the installation or setup,
a job queue to use and its library. Then press the execution
key.
NOTE: • If you use a job queue and the library at their initial values, this program will run
within QBATCH.