Filter
Top Products
7. SUPPLY SPECIFICATIONS
ENGLISH VERSION EO1-33047
7.1 Media
E7- 2
7.1.2 Detection Area of the Transmissive Sensor
The Transmissive Sensor is movable from the centre to the left edge of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
<Label>
<Tag paper with square holes>
N
OTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
3. Backing paper must be wider than a label; the distance between the edge of the backing paper and that of a label
should be at least 1.5 mm.
4. Use of the tag paper of 25 mm to 50 mm in width, and 171
µ
m to 263
µ
m in thickness may shorten the platen life.
5. When using a label stock in cut mode, be sure to cut the gaps. Cutting labels will cause the glue to stick to the
cutter, which may affect the cutter performance and shorten the cutter life.
6. To make tearing off a label easier, set the Auto Forward Wait function (FORWARD WAIT parameter) to ON in
the system mode. Doing so will cause the last label printed to be fed and stopped past the strip shaft. However,
if a next label is issued without tearing off the label on the strip shaft, the label may peel while it is fed backward,
causing a printer failure.
Sensor position
A
rea to be detected.
Centre of media
Print side
Min. 12 mm
Label
Gap
Label
Min. 2.0 mm
Sensor is movable
within this range.
Media feed direction
Sensor position
Centre of media
Min. 12 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
Square holes
(Round holes are not acceptable.)
Print side
Round hole
Min. Ø 2.5mm