Filter
Top Products
2. PRINTER SETUP
ENGLISH VERSION EO1-33062
2.7 Loading the Media
E2- 7
2.7 Loading the Media
This section describes in detail how to load a media roll.
1. Turn OFF the printer.
2. Turn the Cover Open Levers frontward, and open the Top Cover.
3. When the inner core diameter of the media roll is 25.4 mm (1”),
remove the Media Holder Spacers from the Media Holders. The
Media Holder Spacers are required to print media rolls with 38.1-mm
(1.5”) inner core diameter.
4. Insert the Media Shaft into the paper core so that the print side faces
up as shown below.
5. Hold the Media Holder with the smooth side facing the media roll,
align the Media Holder’s centre hole with the Media Shaft, and then
install the Media Holder by sliding it onto the Media Shaft. Make
sure that the media roll is positioned at the centre of the Media Shaft.
WARNING
!
1. Do not touch any moving
parts. To reduce the risk
of fingers, jewellery,
clothing, etc. being drawn
into the moving parts, be
sure to load the media
once the printer has
stopped moving
completely.
2. To avoid injury, be careful
not to trap your fingers
while opening or closing
the Top Cover.
CAUTION!
Be careful not to touch the
Print Head Element when
opening the Top Cover.
Failure to do this may cause
missing dots by static
electricity or other print quality
p
roblems.
Media Shaft
(Accessory)
Media Holder
Media Shaft
Media
Media Holder
Spacer
(
Accessor
y)
Media Holder
(Accessory)
NOTE:
When the outer roll diameter
exceeds 127 mm (5”) or the inner
core diameter exceeds 38.1 mm
(1.5”), an optional External
Media Roll Hanger is required.
F
or details, refer to page 2-12.