Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33062
2.7 Loading the Media
E2- 9
2.7 Loading the Media
(Cont.)
11. After loading the media, manually set the Media Sensor to the
correct position.
The Feed Gap Sensor is included in the right Media Guide. Position
of the Feed Gap Sensor can be set by fitting the Media Guides to the
media ends.
When using the Black Mark Sensor, it should be positioned in line
with the centre of the black marks on the reverse side of the media.
There are three issue modes available for this printer.
Batch mode:
In the batch mode, the media is continuously printed and fed until the
number of media specified in the issue command has been printed.
Black Mark Sensor
Feed Gap Sensor (in the
Media Guide)
CAUTION!
To separate the printed
media from the media roll in
batch mode, be sure to tear
off the media at the Media
Outlet or cut the media past
the Strip Plate. If you tear
off the media at the Print
Head by mistake, be sure to
feed one label (10 mm or
more) with the
FEED/PAUSE Button prior to
a next issue. Failure to do
this may cause a paper jam.
NOTES:
1. The selected sensor type is the
one used in the last print job.
The Feed Gap Sensor has been
selected as the factory default.
To change the sensor type, refer
to Section 2.9.1 Media Sensor
Calibration.
2. When the Media Guides are
fitted to the media edges, the
Feed Gap Sensor is positioned
at 6 mm from the right end of
media.
3. The Black Mark Sensor is
movable in a range of media
width.
6 mm
Feed Gap Sensor
Black Mark Sensor is movable
in the full range.