Toshiba B-SX8T SERIES Barcode Reader User Manual


 
2. PRINTER SETUP ENGLISH VERSION EO1-33057
2.8 Setting an Operating Environment
E2-27
2.8.1 Parameter Setting
(Cont.)
When “CODE MANUAL” is selected and the [PAUSE] key is pressed,
the LCD display will show the setting screen of CONTROL CODE1 to
CONTROL CODE3 as follows.
After setting the control code for Control Code 1, press the [PAUSE]
key to show the CONTROL CODE2 screen. In a same manner, press the
[PAUSE] key after setting the control code for Control Code 2 to display
the CONTROL CODE3 screen.
Press the [PAUSE] key after setting the control code for Control Code 3.
(13) Ribbon Type Selection
This parameter is to choose a ribbon type to be used.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a ribbon type, press the [PAUSE] key.
CONTROL CODE1
CONTROL CODE2
CONTROL CODE3
[PAUSE]
[PAUSE]
<2>PARAMETER SET
RIBBON TRANS
RIBBON NON TRANS
RIBBON TRANS
[RESTART]
[FEED]
Non transparent
ribbon
Transparent ribbon
<2>PARAMETER SET
CONTROL CODE1 1B
[RESTART]
[FEED]
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 01
CONTROL CODE1 00
CONTROL CODE1 FD
CONTROL CODE1 02