Filter
Top Products
Managing Address Book 93
Sending Options tab
In the Sending Options tab, the following items are displayed:
When displaying the properties of a contact in the private address book, you can modify the fol-
lowing settings:
- Use Sub Address and sender information
- Sub Address
- Sender Identification
y Use Device Settings — This is checked when the contact is set to use the device settings
rather than using the settings on this tab.
y Use Sub Address and sender information — This is checked when the subaddress trans-
mission for this contact is enabled. When this is checked, a document will be always sent
using the specified sub address and SID. Also you can use this contact to perform polling
transmission from the mailbox in the remote facsimile using the specified sub address and
password.
y Sub Address — Display the sub address or mailbox number of remote facsimile where a
document will be sent.
y Sender Identification — Display the security password for the sub address if required.
y Selective Polling — Display the mailbox number of remote facsimile where a document will
be retrieved.
y Password — Display the password for the selective polling if required.
y Overseas Calls — This is checked when calling the contact fax number will be oversea call.
y Error Correction Mode — This is checked when the ECM for this contact is enabled.
y Print Transmission Report — This is checked when printing the transmission report after
the transmission is enabled.
y Reduction — This is checked when the attenuation is enabled.
y Short Protocol — This is checked when the short protocol is enabled.
y Line Monitor — This is checked when the Line Monitor for the fax transmission is enabled.
y Line Selection — Display whether the line 1 or line 2 is used for the fax transmission. The
line 2 can be selected only when optional Line 2 board is installed.
y Transmission Type — Display whether the memory transmission or direct transmission is
used for the transmission.
y Internet Fax Mode — Display whether the simple mode or full mode is used for the Internet
Fax transmission. (E-mail reception is not available in the equipment.)