Filter
Top Products
62
3.RECEIVING A FAX
3
3. Relationship between Original and Paper
Acceptable size of paper
Originals received by Fax can be printed on LD, LG, LT, ST, A3, B4, A4, B5 and A5 size paper, and are
printed in the printing range of each size of paper. No printing will occur in the margins borders of the
received originals as indicated by the gray borders on the figures below.
Set the paper in the drawers or the Large Capacity Feeder (optional).
The paper set on the bypass tray is not available.
Drawers can be set for Fax only. See the [Operator's Manual for Basic Function].
• If a specified drawer is set for Fax as a drawer by type, only the paper set in this drawer is used when
the equipment receives a Fax.
• The paper that can be set in the drawer for Fax is LD, LG, LT, LT-R, A3, A4, A4-R and B4 sizes.
* If you want to set ST-R, A5-R, B5 or B5-R size paper in the drawer for Fax, ask your service technician.
Setting RX printing during default setup
The received data are printed on paper which fits the incoming original size.
• When the incoming original is shorter or the same length as the paper printing area, it is printed in the
original size.
• When the incoming original is larger than the paper printing area, it is printed according to the following
priority: (Initial setting: Discard printing ON, Reduction printing ON) To change the configuration to
OFF, see P.158 “4.Setting RX Printing”.
1. When originals are up to 10 mm larger than the printing area; the part of the originals that exceeds the
paper printing area is discarded.
2. When originals are at least 10 mm larger than the printing area; If the original can fit on a single sheet
of paper by reducing it to 90%* of its original size, it is reduced and printed on a sheet of paper (Reduc-
tion printing). If the original cannot fit on a single sheet of paper, it is printed on 2 sheets of paper.
* LG size originals are reduced to 75% to fit onto LT or LT-R paper.
3. Originals are printed on larger size paper.
5 mm 5 mm
5 mm 5 mm
4 mm
5 mm5 mm
4 mm