Toshiba NPX10A Projector User Manual


 
21
Maintenance
AUDIO-OUTAUDIO-INSERIALVIDEOS-VIDEOHDMIMONITOR-OUTCOMPUTER-IN
Connection
Before connection
Read the user’s manual of the device you are connecting to the projector.
Some computers cannot be used with or connected to this projector.
Check for an RGB output terminal, supported signal, etc.
Turn off the power of both devices before connecting.
The figure below shows sample connections. This does not mean that all of these
devices can or must be connected simultaneously.
Monitor
Video recorder,
DVD player, etc.
Audio cable
(not supplied)
Computer
Video cable
(not supplied)
To S-video output
S-Video cable
(not supplied)
Video recorder, etc.
Audio amplifier, etc.
Computer
DVD video recorder,
DVD player, etc.
To audio
output
To video
output
RGB cable
(supplied)
To RGB
output
Audio cable
(not supplied)
To audio
output
RGB cable
(not supplied)
To RGB
output
To YPbPr
output
Monitor cable Mini
D-sub 15P-BNC
(not supplied)
Conversion
adapter BNC-pin
(not supplied)
To HDMI
output
HDMI cable (not supplied)
Audio cable
(not supplied)
To audio
output
Audio cable
(not supplied)
To audio input
White (L)/Red (R)
Notes
Moving pictures played back on computers using DVD software may appear unnatural
when projected with this projector. However, it is not a malfunction of the projector.
When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
Output volume of AUDIO OUT terminal can be adjusted by the VOLUME+/- button.
The MONITOR OUT terminal outputs analog RGB signals or component video signals
(Y/Pb/Pr) from the COMPUTER IN terminal.
A computer monitor usually cannot accept Y/Pb/Pr signals correctly.