Toshiba NPX10A Projector User Manual


 
35
Maintenance
The product’s light source is a mercury lamp that lights at increased internal pressure.
Be sure to fully understand the following characteristics of the lamp and handle it with
extreme care.
The lamp may burst with a loud noise due to impact or deterioration, or fail to light at
the expiration of its life.
How long it takes before the lamp bursts or the life expires may vary greatly by lamp.
Some may burst shortly after first use.
Burst is likely to happen if the lamp is used after the replacement period has
elapsed.
When the lamp bursts, the broken pieces of glass may get inside the product or be
released outside from the openings for ventilation.
When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along
with glass dust may be released from the openings for ventilation.
Immediately replace the lamp when a replacement mes-
sage appears on the screen.
When the replacement time approaches, a message will appear on the screen.
The risk of burst will increase if the lamp is continuously used without being re-
placed.
Frequently check the used hours. (Refer to the Options setting menu.)
p.34
When the lamp is broken
If glass components, including a lamp and a lens, should break, handle the broken
pieces with care to avoid injury and contact your dealer for repair service.
In the event of lamp burst, unplug the product from the wall outlet, leave and com-
pletely ventilate the room. Then, thoroughly clean the area around the projector and
discard any edible items placed in that area, as they may be contaminated.
When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your
eyes or is inhaled.
About lamp