Filter
Top Products
4.13 Touch pad 4 Replacement Procedures
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-35
Installing the Touch pad
The following describes the procedure for installing the touch pad. (See Figure 4-21 to 4-23.)
1. Connect the touch pad cable to the connector on the touch pad.
2. Stick the glass tape in place.
NOTE: When installing a new touch pad, reuse the double-sided tape and insulator and
stick them in place. If the adhesive strength of the double-sided tape and
insulator on the touch pad is weak, replace it (them) with a new one.
3. Install the touch pad in place.
4. Connect the touch pad cable to the connector CN3240 on the system board.
5. Install the touch pad cover while engaging the latches.