Filter
Top Products
4.17 Microphone 4 Replacement Procedures
4.17 Microphone
Removing the Microphone
The following describes the procedure for removing the microphone. (See Figure 4-29.)
1. Peel off the glass tape and disconnect the microphone cable from the connector
CN6050 on the system board.
2. Remove the microphone from the slot.
Microphone
Microphone cable
CN6050
Glass tape
Figure 4-29 Removing the microphone
Installing the Microphone
The following describes the procedure for installing the microphone. (See Figure 4-29.)
1. Install the microphone to the slot.
2. Connect the microphone cable to the connector CN6050 on the system board.
3. Stick the glass tape in place.
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-43