Filter
Top Products
39
Operations
CONTENTS
CALL
Notes
• The information displayed is not refreshed even if it changes. To refresh the information, turn
off the information display, then turn it back on.
• The information display turns off if any other operation is performed.
• The “Lamp time” shows an approximate time for lamp replacement. (It should not be used as a
lamp warranty time counter.) If the time indicated here nears 1500, contact your store of
purchase about obtaining a replacement lamp (TLPL55, sold separately).
• The “Lamp time” can be reset when the lamp is replaced.
• The “Version” is the version of the control program used in the projector and is used for
servicing, etc.
MENU
ON /
INPUT
ENTER
CT-90106
KEYSTONE AUTO SET
EXIT /
P.MODE
PIP
FREEZE
MUTE
CALL
RESIZE
VOL
/
ADJ
STANDBY
CALL
Displaying Information
Information on the input signal source, etc., can be displayed.
Remote control
Press CALL.
The information described below is displayed.
The information display turns off when the CALL button is
pressed again.
Status display
Input - current input source
H-resolution - the horizontal resolution of the input signal (at RGB input)
V-resolution - the vertical resolution of the input signal (at RGB input)
H-frequency - the horizontal frequency of the input signal (at RGB input)
V-frequency - the vertical frequency of the input signal (at RGB input)
Sync - the polarity of the sync signal (at RGB input)
Video mode - the color mode of the video signal (at Video, S-Video input)
Signal format- the formatting of the Y/P
B/PR signal (at Y/PB/PR input)
Lamp time - the elapsed usage time of the lamp
Version - the version of the firmware
Shutter - the shutter speed of the document imaging camera (at
document imaging camera input)