Filter
Top Products
Getting Started System Information (sysinfo) Page
Trango Broadband Wireless — Atlas5010 page 14
[Eth In] 55,256,030 bytes 24 Kbps
[Eth Out] 3,348,202 bytes 3 Kbps
[RF In] 1,377,125 bytes 0 Kbps
[RF Out] 45,499,374 bytes 44 Kbps
[ARQ Retransmission] 881 pkts
Success.
#>
To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number.
Example:
#> sysinfo 2
********************************* 2 *********************************
[Radio Temp] 32 C [PoE Voltage] 14.2 V
[Opmode] on [Default Opmode] on
[Active Channel] 20 v [Freq] 5755 MHz
[Speed] 54 Mbps [Tx Power] 17 dBm [Power Range] -4..17 dBm
[Peer ID] DE1B7747 [Status] connected [RSSI] -44 dBm
[Peer IP Config] 10.8.2.139 255.255.255.224 10.8.2.129
Success.
Each of the parameters within the sysinfo screen is defined below
Section 0
[Model] Radio Model # (P5010M)
[Unit Type] User defined Unit Type (MU or RU)
[Hardware Version] Hardware version set by factory (5010)
[Firmware Version] Current firmware version loaded in radio
[System Up Time] Time since last reboot or power cycle
Section 1
[MAC] MAC address of radio
[S/N] Serial Number of Radio
[IP] User defined IP Address of radio
[Subnet Mask] User entered IP Subnet Mask
[Gateway] User entered IP address of the default router or gateway on the local
Ethernet segment
Section 2
[Radio Temp] The internal temperature of the radio in Celsius
[POE Voltage] The voltage the radio is receiving from the POE
[Opmode] Operation mode of the radio: ON = transmitting, OFF= not transmitting
[Default Opmode] Opmode which the radio defaults to after reboot.
[Active Channel] Active RF Channel and Antenna polarization
[Freq] Frequency of active channel
[Speed] Modulation Speed (6,12,18,24,36, 54 Mbps)
[Tx Power] Transmit Power
[Power Range] Allowable power range for chosen Frequency (dBm)
[Peer ID] MAC Address of remote radio
[Status] Connection status of remote radio (connected or disconnected)
[RSSI] Measured signal strength from remote radio (dBm)
[Peer IP Config] Remote radio’s IP subnet, and default Gateway configuration