Filter
Top Products
Getting Started
Trango Broadband Wireless — Atlas5010 page 14
[Eth In] 2,162,862 bytes 0 Kbps
[Eth Tx] 1,098,403 bytes 4 Kbps
[RF Rx] 471,841 bytes 0 Kbps
[RF Tx] 2,233,369 bytes 0 Kbps
Success.
#>
To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number.
Example:
#> sysinfo 2
********************************* 2 *********************************
[Opmode] on [Default Opmode] on
[Active Channel] 2 h [Freq] 5280 MHz
[Speed] 36 Mbps [Tx Power] 7 dBm [Power Range] -4..7 dBm
[Peer ID] DE1B784B [Status] connected [RSSI] -75 dBm
[Peer IP Config] 10.254.1.3 255.255.255.248 10.254.1.1
Success.
#>
Each of the parameters within the sysinfo screen is defined below
Section 0
[Model] Radio Model # (P5010M)
[Unit Type] User defined Unit Type (MU or RU)
[Hardware Version] Hardware version set by factory (5010)
[Firmware Version] Current firmware version loaded in radio
[System Up Time] Time since last reboot or power cycle
Section 1
[MAC] MAC address of radio
[S/N] Serial Number of Radio
[IP] User defined IP Address of radio
[Subnet Mask] User entered IP Subnet Mask
[Gateway] User entered IP address of the default router or gateway on the local
Ethernet segment
Section 2
[Opmode] Operation mode of the radio: ON = transmitting, OFF= not transmitting
[Default Opmode] Opmode which the radio defaults to after reboot.
[Active Channel] Active RF Channel and Antenna polarization
[Freq] Frequency of active channel
[Speed] Modulation Speed (6,12,18,24,36, 54 Mbps)
[Tx Power] Transmit Power
[Power Range] Allowable power range for chosen Frequency (dBm)
[Peer ID] MAC Address of remote radio
[Status] Connection status of remote radio (connected or disconnected)
[RSSI] Measured signal strength from remote radio (dBm)