Filter
Top Products
Appendix A Command Set Reference
Trango Broadband Wireless — Atlas5010 page 37
RF Out: Counter for Ethernet packets which exited over-the-air out the radio.
Configuration Page
IP Address: The IP address of this radio; used to manage the radio's application layer.
Subnet Mask: The subnet mask of the radio.
Gateway: The default gateway of the radio.
Default Opmode: Operation mode of the radio after power cycle. When Opmode is \"On\" the
radio will attempt to make a wireless connection. When Opmode is \"Off\" the
radio is not transmitting, but can be managed from the wired side. In addition
to setting Default Opmode to \"Off\", Opmode can be set to \"Off\" by
interrupting the radios boot-up cycle in the first 30 seconds after power up
Peer ID: User entered MAC address of the partner unit.
Switch: Checked means active
Auto Rate Shifting When enabled, radio will automatically shift TX rate up or down depending
on link quality.
Autoscan MU (RU Only). If this switch is enabled, when not connected to MU, the RU will
automatically automatically scan all available channels and frequencies
RSSI LED Enables and disables RSSI LEDs. Disabling the LEDs provides slight
improvement to radio performance. Typically RSSI LEDs should be enabled
during alignment and disabled during normal operation.
Active Channel/Polarization: The current channel and polarization of the radio when Opmode is \"On\".
Speed: Transmit over-the-air raw data rate.
Power: Transmit RF power setting.
Range: Allowable range of the transmit power based on the current settings of the
active channel and the speed.
Remarks: A descriptive text field for general use (i.e. the location of the unit). It does
not affect system performance.
MIR: Set Maximum Information Rate for network traffic.
ARQ: . Auto Retransmit Request. When enabled, dropped packets are detected at
the receiver and retransmitted by the transmitter.
Encrypt: . Encryption. Enables and disables proprietary 128 bit over-the-air encryption.
Key: . 128 Encryption Key. Must match in both MU and RU.
Activate Opmode On: Activates radio's Opmode to "On"-transmitting.
Activate Opmode Off: Activates radio's Opmode to "Off" not-transmitting.