Filter
Top Products
Configuration
Trango Broadband Wireless — Atlas5010 page 24
defaultopmode [on|off] Set or display default opmode. Radio must be set to opmode ON to
establish wireless link.
Default setting=OFF
encrypt [on|off] Enable or disable proprietary 128 bit tx encryption.
Default setting=OFF
encrypt key <key> Change encryption key (128 bits)
<key> = xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
exit Exit telnet session
freq [<ch#> <antenna>] Set or display channel and antenna selection.
freq writechannel <ch#> <freq>… Modify channel table, up to 6 channels at a time.
freq writechannel default Restore factory default channel table.
help [<command>] Display command usage and syntax.
ipconfig [<ip> <subnet> <gateway>] Change ip configuration.
<ip> = ip address
<subnet> = subnet mask
<gateway> = gateway ip address
linktest <local tx rate> <peer tx rate>
[<pkt size> [<# of pkt> [<# of
cycle>]]]
RF link loopback test .
This is the primary loopback test utility for evaluating over-the-air
link quality. Provides link reliability information and dropped packet
statistics. Standard linktest transmits 1600 byte packets, 1000
packets per second for 10 cycles. User can specify packet size,
quantity of packets, number of cycles
<tx rate> = 6,12,18,24,36,48,54 Mbps
mir [<kbps>] Set or display tx maximum information rate (MIR). MU and RU
can be set with different mir for asymmetric upload and
download.
<kbps> = 100..50000
opmode [on|off] Set or display operation mode (on or off)
password <ro|rw|upgrade>
Change password.
<ro> = for read-only
<rw> = for read-write
<upgrade> = for upgrading firmware
peerid [<peer device id>] Set or display peer device id.
power [<dBm>] Set or display tx power..
<dBm> is limited by area (ref: “sysinfo 4”)
reboot Reboot unit.
remarks Enter user remarks up to 80 characters.
reset Restore all factory defaults except ipconfig and passwords.
rssi Display RF relative signal strength indication (rssi) from peer radio.
rssiled [on|off] Enable or disable rssi LED update.
speed [<tx rate>] Set or display tx rate
<tx rate> = 1,2,6,9,11,12,18,24,36,48,54 Mbps
survey [<sec>] Display noise floor for current channel .
<sec> = period 10..3600 default = 10
survey <sec> all Display noise floor for all available channels.
survey <sec> [<ch#> [..]] Display noise floor for selected channels.
sysinfo Display all system information.