Filter
Top Products
HD Mesh Node
Trango Broadband Wireless — High Density MESH page 13
Command Line Interface
The Web browser interface covers very basic features in a limited role. The command line interface
(CLI) provides much more functionality, and is usually the management tool of choice for experienced users.
The CLI can be accessed through Telnet or Console cable.
Telnet
Open a command prompt (DOS) session on your PC. Open a Telnet session by typing:
telnet [ip address of router]
All HD mesh units are pre-configured at the factory. The factory default username is admin and password is
trango. Once you connect to the router you will be greeted with the current RouterOS version information and
prompted for a login.
CLI Login Example
C:>telnet 192.168.100.100
MikroTik v2.9.32
Login: admin
Password:
MMM MMM KKK TTTTTTTTTTT KKK
MMMM MMMM KKK TTTTTTTTTTT KKK
MMM MMMM MMM III KKK KKK RRRRRR OOOOOO TTT III KKK KKK
MMM MM MMM III KKKKK RRR RRR OOO OOO TTT III KKKKK
MMM MMM III KKK KKK RRRRRR OOO OOO TTT III KKK KKK
MMM MMM III KKK KKK RRR RRR OOOOOO TTT III KKK KKK
MikroTik RouterOS 2.9.32 (c) 1999-2006 http://www.mikrotik.com/
Terminal ansi detected, using single line input mode
[admin@HDMESH] > quit
To terminate a CLI session (Telnet or Serial) type the command quit.
Note: Type ? for a listing of CLI commands and directories. More basic information on the CLI will
be covered throughout this text for advance CLI commands reference Mikrotik’s website for
documentation www.mikrotik.com