Filter
Top Products
29
To change the port setting, click on the ID parameter to enter to the
selected port to configure its Speed/Disable, Flow control and Port
Bandwidth Rate Control Ingress and Egress.
Figure 17.
Speed/Disable:
This setting has six modes—100M Full, 100M Half, 10M Full, 10M
Half, Auto and Disable—for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set FlowCtrl to Enable to avoid data transfer overflow.
Or it sets to Disable; there is either no flow control or other
hardware/software management.
When the 10/100M port is set to full duplex mode, then the flow
control will automatically set to disable; and if the 10/100M port is set
to half duplex mode, the flow control will automatically set to enable.
Bandwidth Rate Control Ingress/Egress rate:
This Switch support the Port Bandwidth Rate Control, and will work
only on the auto mode.
30
VLAN Settings (Virtual Local Area Network)
Group individual ports into a small “Virtual” network of their own to
be independent of the other ports. To add a VLAN group, press “Add
Group” button, the new VLAN configuration window will pop out,
you can fill in the description in order to describe this VLAN Group,
check on the port to be a member to this VLAN Group, and press
“Apply” button to execute the setting.
Figure 18. VLAN Group Settings
Once you want to modify the VLAN Group, check on the ID
parameter, the ID VLAN configuration window will pop out.
Figure 19. VLAN Settings