Filter
Top Products
31
Trunk Setting
The Trunk function enables to cascade two or more devices with a
larger bandwidths.
There are three Trunking groups to be set; and there are default ports
in each member. Checked “Enable” to use the trunk function, select
the ports in each member to be trunk, and click “Apply” to activate the
selected trunk group.
Figure 20. Trunk Settings
Be sure that the selected trunk setting port must connect to the
device with a same VLAN group.
32
Mirror Setting
Port Mirroring is a method of monitoring network traffic that forwards
a copy of each incoming and/or outgoing packet from one port of a
network switch to another port where the packet can be studied. It
enables the manager to keep close track of switch performance and
alter it if necessary.
Configuring the port mirroring by assigning a source port from which
to copy all packets and a sniffer port where those packets will be sent.
The selection of the sniffer mode is as follow:
TX (transmit) mode: this mode will duplicate the data transmit from
the source port and forward to the sniffer port.
RX (receive) mode: this mode will duplicate the data that send to the
source and forward to the sniffer port.
Both (transmit and receive) mode: this mode will duplicate both the
data transmit from and data that send to the source port, then it will
forward to the sniffer port.
Figure 21.