Filter
Top Products
3
Mounting
Your UPS may be rackmounted in 4- or 2-post racks. To mount the UPS in a 4-post rack, use the included hardware and
follow the procedure outlined below. To mount the UPS in a 2-post rack, purchase the appropriate hardware, sold separately
(order Tripp Lite model # 2POSTRMKIT). The procedures are for common rack types and may not be appropriate for
all rack configurations. User must determine the fitness of rackmount hardware and procedures before mounting.
Color Selection
Your UPS is shipped with a grey front panel, 2 grey mounting ears and 2 black mounting ears. To match grey equipment,
mount the grey ears in front. If you would like your UPS to match black equipment, you may request the alternate (black)
front panel for 3U UPS systems (Tripp Lite part #AC4134) by calling (773) 869-1234.
Suggested Rackmount Installation
for 4-Post Enclosures
Connect the two segments of each shelf using the included
screws and nuts . Leave the screws slightly loose so that the
shelves can be adjusted in the next step.
Adjust each shelf to fit your rack, then mount them in the lowest
available space of your rack with the screws, nuts and washers
provided . Note that the support ledges should face inward.
Tighten the screws that connect the shelf segments .
Attach mounting ears to the front mounting holes of your
equipment using the screws provided . The ears should face
forward.
Using an assistant if necessary, lift your equipment and slide it
onto the mounting shelves. Attach your equipment to the rack
by passing user-supplied screws, nuts and washers through its
mounting ears and into the rack rails.
G
FE
D
B
C
B
A
1
2
3
A
B
1
C
B
2
E
D
F
3
4
4
G