Tripp Lite SU10KRT1X Power Supply User Manual


  Open as PDF
of 21
 
6
1
2
3
4
N1
B1
B2
S2
N1
B3
B5S3
S3
B4
S1
S4
4 – Mounting continued
4-2 Placement
4-3 Mounting (Rack)
InordertominimizethepossibilityofdamagetotheUPSsystemandmaximizeitsoperationallifespan,followthelocationwarningslistedin
Section 2 – Important Safety Instructions. Remember to keep at least 30 cm clearance from the rear panel of the UPS system to the wall and
do not block any of the UPS system’s front or rear ventilation openings.
Warning: The UPS system is very heavy—be careful when moving or lifting it.
• UsetheincludedrackmountshelvesandmountinghardwaretomounttheUPSsystemina4-postrackorrackenclosure.TomounttheUPS
systemina2-post(telecom)rack,orderTrippLite’s2-PostRackmountKit(model2POSTRMKITWM,soldseparately).
• Theinstructionsinthismanualareforcommonrackandrackenclosuretypesandmaynotbeappropriateforallmountingapplications.The
usermustdeterminethefitnessofhardwareandproceduresbeforemounting.Ifhardwareorproceduresarenotsuitablefortheapplication,
contact the manufacturer of the rack or rack enclosure for a solution.
4-Post Mounting Procedure
Note: The mounting procedure is identical for the external battery pack and the UPS power module. Mount the external battery pack
first, then repeat the procedure for the UPS power module. The external battery pack should be mounted in the lowest available rack
space. The UPS power module should be mounted directly above the external battery pack.
1
Adjust the depth of the mounting shelves
B3
and
B4
tofittherack,thenmounttheshelvesinthelowestavailablerackspace.Insertcage
nuts
N1
through the smaller square holes of the shelves, then attach the shelves to the rack’s vertical mounting rails. (The shelves should face
inward.)UseM5flat-headscrews
S3
forthefrontandrearverticalrails;usewasherplates
B5
for the front vertical rails only. Tighten all
screws before proceeding.
2
UseM4flat-headscrews
S2
to attach pulls
B1
to the mounting brackets
B2
.
3
UseM3flat-headscrews
S1
to attach the mounting brackets to the cabinet.
4
Withtheaidofanassistant,liftthecabinetandplaceitonthemountingshelves.InsertM5pan-headscrews
S4
through the mounting
brackets and into the vertical mounting rails. Tighten all screws securely.
 previous next