26
Appendix B
Clear Log-in Information
If you are unable to perform an Administrator login (because the Username and Password information has
become corrupted, or you have forgotten it), you can clear the login information with the following
procedure:
1. Power off the switch and remove the top cover from the unit chassis.
2. Short the jumper labeled Default Password on the switch’s main board.
3. Power on the switch.
When you power the switch on, the following message appears on the LCD display:
USERNAME AND PASSWORD INFORMATION HAS BEEN CLEARED. PLEASE POWER OFF
THE SWITCH, REMOVE THE JUMPER, CLOSE THE CASE, THEN RESTART.
4. After you start back up, the OSD login function acts exactly the way it did the first time the switch was
run and you can reset passwords for the Administrators and Users.
200506056 93-2463 Console KVM OM.qxd 6/29/2005 12:30 PM Page 26