Filter
Top Products
2.3 Installing hard drives
Chapter 2: Setting up 23
2.3.2 Installing SATA/SCSI hot swap drives
1. Press the release clip and pull the release lever to unlock
the drive tray from the chassis.
2. Pull the empty drive tray from the chassis.
3. Remove the four screws holding the plastic spacer in
place in the drive tray and remove it from the tray.
4. Place a SATA or SCSI drive in place in the drive tray and
secure with four screws.
Screws Required Location
6 Pan Head screws, #6-32-L6 B type Backplane
2 Hex head #6-32-L6 Cradle locking bar