Filter
Top Products
30
2.10 - Installing the Power Supply
There are three power connectors on your Tempest i5000PX S5380. The
Tempest i5000PX S5380 requires that you have an EPS12V power supply that
has a 24-pin, an 8-pin and a 4-pin power connectors. Except the 24-pin and 8-
pin power supplies, you also need to connect a 4-pin power supply for the
power of South Bridge.
NOTE: Please be aware that ATX 2.x, ATX12V and ATXGES power supplies
may not
be compatible with the board and can damage the motherboard and/or
CPU(s).
24-Pin EPS/12V Power Connecto
r
8-Pin 12V Power Connector
4-Pin 12V Power Connector
Applying power to the board
1. Connect the 12V 8-pin power connector.
2. Connect the EPS/12V 24-pin power connector.
3. Connect the 4-pin power connector.
4. Connect power cable to power supply and power outlet
NOTE
YOU MUST unplug the power supply before plugging the power cables
to motherboard connectors.
2.11 - Finishing up
Congratulations on making it this far! You’re finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by calling your vendor’s support line.