Filter
Top Products
Quick Start Guide Ultra Electronics Card Systems
Page 14 MAGICARD TURBO Color Printer
Switch the printer OFF. Locate the
UltraSecure Interface connector on the
rear panel.
Note the position for the UltraSecure Key
at the rear of the Magicard Printer.
Please note that the UltraSecure logo is now a
standard feature programmed into the firmware of all
TURBO models. It can be switched on/off from within
the OVERCOAT section of the PrintMagic driver.
If you wish to have a CUSTOM LOGO produced you
must ask your dealer for a custom key order form.
Your logo will then be programmed into a key of the
type shown above. When the key is plugged into your
Turbo it will override the internal programme and your
logo will be printed instead of the standard
UltraSecure logo.
Plug a good quality, screened Centronics
Interface cable into this socket and
secure the wire latches. Plug the other
end into the Printer connector of your PC
(LPT1 or LPT2)
Connection of the parallel cable to the
rear 25-way connector on the PC.
Install the parallel Interface Cable
and Ultra Secure Key
I
1
3
2
4