Filter
Top Products
Ultra Electronics Card Systems Quick Start Guide
MAGICARD TURBO Color Printer Page 25
Area
If area is selected the
coordinates define the start
and end of the overcoat area
Window
If window is selected the
coordinates define the start
and end of the area that has to
remain blank (no overcoat)
It is possible to define up to 10 overcoat
areas or windows, they will be combined
to one area or window on the card.
Prev Switch to previous overcoat area
(or window)
Next Switch to next overcoat area (or
window )
Enable Enable checkbox can be used to
turn overcoat feature on and off.
Note that the enable checkbox is
valid for all overcoats (1 - 10)
Film Power Setting
The film power settings allow the user to
adjust the density for the YMC, the Resin
and the Overcoat print. If using earlier
models, please leave the settings at
default value of 50, to prevent file errors.
Black Format Options
The black format options enable the
operator to use resin panel for fonts only,
for every black spot on the card or not at
all.
Ultra Secure Feature
With this checkbox the user can switch
the Ultra Secure feature on and off,
provided the Ultra Secure Key is installed
on the printer.
180 Degree Rotation
This option is used to rotate the complete
card layout 180 degrees to adjust for the
chip position (on left or right side of the
card) or the magstripe position (on the top
or bottom of the card).
Back Side
If Duplex mode is enabled (in Setup), this
button can be used to switch the ‘Options’
dialogue to back side, to set the options
for the back of the card. The dialogue for
the back will look as follows:
The same options can be set as for the
front. With the ‘Front Side’ button, the
user can switch back to the front. Note
that in Duplex Mode the options ‘Back
Side Only’, ‘Manual Flip Mode’ and
‘Magstripe Only’ are not applicable and
therefore not available.
Hand Fed Mode - If this switch is checked
the printer will not feed a card from the
hopper but will allow the operator to insert
a card from the front. It the card is not
inserted within 20 seconds when
prompted then the printer will return to
standby.
Back Side Only - This option will only
work on Magicard Flip models as they
have the ability to print double sided
cards. The image will allow a magnetic
stripe card to be encoded and printed on
the back only. `
Manual Flip Mode - Allows operators,
running non-flip models, to manually turn
the printed card over and reinsert for
printing on the back.
Magstripe Only - For magnetic encoding
models only. Checking this box will
prevent any printing on the card, but will
encode on the magstripe only.
Color