Filter
Top Products
Quick Start Guide Ultra Electronics Card Systems
Page 24 MAGICARD TURBO Color Printer
Paper Size
Use Paper Size to
determine the printed area
of the card. Standard Size
or Full Bleed (Magicard 300
plus only) can be selected.
Copy Count
Sets the number of copies
printed of each card.
Film Type
Tells the printer which kind
of dye film you have
installed. The following film
types are available:
YMCKO-Resin
YMCKO-Diffusion
YMCKO-Short Panel
KO-Resin
KO-Diffusion
K-Resin
K-Diffusion
YMCKOK-Resin
Duplex
Tells the printer if one or
two sides of the card must
be printed.
Orientation
Determines if the card will
be printed in portrait or
landscape.
Options
If the ‘Options’ Tab is selected, you will
find the following options:
Data Transfer Format
This option will speed up the downloading
process from the PC to the printer. To
enable this option click on the
“Compressed Box” so a tick appears in
the window of the box.
Click on the downward pointing arrow
directly below the compressed box and
select one of the following settings: 4, 5,
6, or 7 bit options. The lower the number
of bits the faster the download speed.
Please note:
The maximum 4-bit Data Transfer Format
when selected may produce picture
quality degradation when printing high-
resolution graphics files. To reduce this
effect select the 5-bit data transfer format.
Overcoat Settings
In this section of the ‘Options’ page, the
overcoat can be enabled and the overcoat
area can be defined.
BLX
BLX is the bottom left X-
coordinate
BLY
BLY is the bottom left Y-
coordinate
TRX
TRX is the top right X-
coordinate
TRY
TRY is the top right Y-
coordinate