Filter
Top Products
Scanning Memory Banks
To scan the memories you have programmed, press SCAN. The scanner
scans all unlocked programmed memories in enabled memory banks,
stopping on a memory when it detects a transmission. To turn on/off
memory banks, while scanning press the number button that corresponds
to the memory bank you want to enable or disable.
Locking/Unlocking Memories
You can lock memories so that they are not scanned, even if their bank is
turned on. Simply press L/O when the scanner stops on a transmission
on the frequency or manually select the memory (see page 30 for
“Selecting a Memory” section), then press L/O. The scanner turns on the
L/O icon when it is set to a memory that is locked out.
To unlock a memory, manually select the memory, then press L/O.
The scanner turns off the
L/O icon and includes the memory when
scanning its bank.
To unlock all memories, press and hold L/O for 2 seconds, the scanner
beeps twice and the
L/O icon disappears.
Using Priority Scan
You can set one memory in each bank as a priority memory. If you turn
on the Priority feature, the scanner will check the priority memories in
enabled banks every 2 seconds, even if it has stopped on a transmission
on another memory.
To set the memory in a bank to be the priority memory, manually select
the memory then, while holding on the memory, press E/PGM to put the
scanner in program mode and press PRI. The scanner turns on the
PRI
icon when it is stopped on a memory designated as priority.
To turn on Priority Scan, press PRI while the scanner is scanning or
holding on a memory (but not in program mode). You will notice a short
break in audio every 2 seconds as the scanner checks the enabled
priority memories. If there is a transmission on a priority memory, the
scanner will immediately tune to that memory.
31
Using the Scanner Memories
UB338ZH(BC370CRS) 2/23/06 9:25 AM Page 31