Filter
Top Products
If you experience difficulty while in TrunkTracker™ mode,
try the following steps.
Problem Suggestion
Scanner won’t track the trunked
system.
1. May not be a system which can be tracked by
your scanner.
2. Missing the data frequency.
3. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 56.
Scanner won’t stop during Scan
List mode.
1. No IDs have been programmed.
2. The IDs you have stored are not active.
Scanner will not acquire data
channel.
1. Adjust the squelch for trunking mode.
See page 39.
2. Missing the frequency used for the data
channel. Check your frequency list.
Missing replies to conversations. 1. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 56.
2. Try another Preset Fleet Map or Program
your own Fleet Map.
3. Check to see that all of the systems
frequencies have been entered.
Channel Activity Indicators are
flashing but no sound is heard.
1. May be a private or telephone
interconnect call, which are intentionally
blocked by your scanner.
2. The ID in your display is not active.
Scanner not tracking an EDACS
system properly.
1. Logical channel numbers ( frequencies)
for the system are not programmed in the correct
order. Check frequency resources and reprogram.
2. Not all frequencies for the system are
programmed. Check frequency resources.
If you still cannot get satisfactory results while using your
scanner or if you want additional information, please call or
write the Uniden Parts and Service Division. The address
and phone number are listed in the Warranty at the end of
this manual. If you would like immediate assistance, please
call Customer Service at (800) 297-1023.
If you have internet access, you can visit
www.uniden.com or www.trunktracker.com or
www.bearcat1.com/free.htm for additional information.
77
C:\Manuals\BC245 VA\BC245 VA rev.vp
Fri Nov 12 10:32:47 1999
Color profile: Disabled
Composite Default screen