Filter
Top Products
106
Using the Close Call Feature
• Set CC Bands: Lets you select the Close Call
band settings. You can turn the following bands
on or off.
VHF Low 1 (25.0000-53.9800 MHz)
VHF Low 2 (54.0000-107.9000 MHz)
Air Band (108.0000 - 136.9750 MHz)
VHF High1 (137.0000-224.9800 MHz)
VHF High2 (225.0000-319.9500 MHz)
UHF (320.0000 - 512.0000 MHz)
800MHz+ (764.0000 - 775.9875 MHz,
794.0000 - 823.9875 MHz,
849.0125 - 868.9875 MHz,
894.0125 - 956.0000 MHz,
1240.000 - 1300.0000 MHz)
Use the scroll control to select a band, press
the scroll control, then use the scroll control to
select On or Off and press the scroll control.
Turning off undesired bands speeds up Close
Call operation. (The Close Call feature does not
work for frequencies greater than 956 MHz.)
Close Call Hits
When the scanner detects a Close Call hit, it alerts you
according to the Override and Alert settings in the
previous section. While listening to a Close Call hit,
you can press Hold to hold on the hit frequency, press
the scroll control to quickly save the frequency into
memory, press L/O to lock out the frequency from
Close Call and Search operation, or wait for the
transmission to end. If you are in Close Call Only or
Close Call Override mode, and you do not press any
key, the scanner returns to its previous operation after
the transmission ends and the set delay time expires.
If you are holding on the frequency, press Hold again
to resume the previous operation.