Filter
Top Products
7
Applying Power for Vehicle Installation
You can power your scanner using either the supplied DC power cord or your vehicle’s
cigarette lighter socket using DC cigarette lighter power cord.
Caution: You must use a power source that supplies 13.8 V DC and delivers at least
700 mA. Your standard 12V car battery should be sufficient. The cord connector’s
centre tip must be set to positive and its plug must fit the scanner’s DC 13.8 V
jack. The supplied DC power cord meets these specifications. Using a power cord
that does not meet these specifications could damage the scanner or the adaptor.
• Always connect the adaptor or DC power cord to the scanner before you connect it to the
power source. When you finish, disconnect the adaptor or DC power cord from the power
source before you disconnect it from the scanner.
• For added safety and to protect your scanner,
disconnect the cable from your vehicle battery’s
negative (-) terminal before you begin.
Follow these steps to connect the supplied DC power cord.
1. Connect the power cord’s black wire to a chassis ground, such as a metal screw
attached to a metal part of the vehicle’s frame. Be sure that the screw is not insulated
from the frame by a plastic part.
2. Connect the power cord’s red wire (with in-line fuse)
to a source of voltage that turns on and off with the
ignition switch, such as a spare accessory terminal in
your vehicle’s fuse box.
3. Insert the power cord’s barrel plug into the DC 13.8 V
jack on the back of the scanner.
4. Reconnect the cable to the vehicle battery’s
negative (-) terminal.
To power the scanner from a vehicle’s 12 V power source
(such as a cigarette-lighter socket), use the supplied cigarette-lighter adaptor cord.
To connect the supplied DC cigarette-lighter power cord, insert its barrel plug into the
DC 13.8 V jack on the back of the scanner, then plug the power cord into your vehicle’s
cigarette lighter socket.
Note: If you use a cigarette-lighter power cord and your vehicle’s engine is running, you
might hear electrical noise from the engine while scanning. This is normal.