Filter
Top Products
NTI UNIMUX MULTI-USER KVM SWITCH
6
INSTALLATION
It is not necessary to turn OFF power to CPUs or monitors during this installation unless RS-232 is going to be connected. All
cables, except for the RS-232 cables, may be hot plugged.
If using RS-232 Control see RS-232 section on page 29 for more information. Observe normal precautions when connecting the
RS232 cables to the CPU. Refer to the owner’s manual for the CPU being connected for precautions, if any.
1. Connect the 15HD male cable end from each user monitor to the female 15HD ports labeled "MONITOR x " on the rear of the
UNIMUX switch. See Figure 2.
Figure 2- Install user monitor(s)
Rear View of UNIMUX
MONITOR 1
MONITOR 2
MONITOR 3
MONITOR 4
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
VIDEO 5
VIDEO 6
VIDEO 7
VIDEO 8
VIDEO 9
VIDEO 10
VIDEO 11
VIDEO 12
VIDEO 13
VIDEO 14
VIDEO 15
VIDEO 16
USER 1
USER 2USER 3USER 4
R
S
2
3
2
CPU 1CPU 2CPU 3CPU 4CPU 5CPU 6CPU 7CPU 8CPU 9CPU 10CPU 11CPU 12CPU 13CPU 14CPU 15CPU 16
NTI
NETWORK
TECHNOLOGIES
INCORPORATED
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Aurora, OH 44202
www.nti1.com
R
15HD Male
Video Connector
15HD Female
Video Connector
Monitor
MONITOR 1