Filter
Top Products
NTI UNIMUX MULTI-USER KVM SWITCH
36
Figure 37- Cascaded configuration with single-user masters
Cable Connections
The same cable used to connect a CPU to the UNIMUX is used to connect two UNIMUX switches together- USBVEXT-xx-MM.
No other cables will be necessary. To connect a slave to a master
1. Connect the USB-A-male end of the USBVEXT-xx-MM to the USER 1 port on the slave.
2. Connect the 15HD male at the same end of the USBVEXT-xx-MM cable to the MONITOR 1 port on the slave.
3. Connect the USB-B-male end of the USBVEXT-xx-MM to the CPU 1 port on the master.
4. Connect the 15HD male at the same end of the USBVEXT-xx-MM to the VIDEO 1 port on the master.
Repeat this procedure for each USER and MONITOR port on the slave that is desired to be controlled through the master. Any
USER and MONITOR ports that do not get connected to the master can be connected to by users. Users connected to a slave
downstream from the master will control only the CPUs directly connected to that slave switch (i.e. users 5 and 6 in Figure 37 can
only control CPUs 25-40).
USER 1
USER 2 USER 3 USER 4
USER 5
USER 6
UNIMUX-8X16
UNIMUX-4X8
SLAVE
SLAVE
CPU PORTS
CPU PORTS
USER PORTS
USER PORTS
CPU1 CPU 8
Users 5-8 only have access to CPUs 25-40.
Users 1-4 have access to all CPUs
USER 7
USER 8
CPU 25 CPU 40
USBVEXT-xx-MM
(8 CABLES)
USBVEXT-xx-MM
(16 CABLES)
CPU PORTS
USER PORT
MASTER
UNIMUX-1X4
CPU PORTS
USER PORT
MASTER
UNIMUX-1X4
CPU PORTS
USER PORT
MASTER
UNIMUX-1X4
CPU PORTS
USER PORT
MASTER
UNIMUX-1X4
UNIMUX-4X8
SLAVE
CPU PORTS
USER PORTS
CPU9 CPU 16
USBVEXT-xx-MM
(8 CABLES)
UNIMUX-4X8
SLAVE
CPU PORTS
USER PORTS
CPU17
CPU 24
USBVEXT-xx-MM
(8 CABLES)
(TO USER PORT 3 ON
SLAVES 1-4)
(TO USER PORT 4 ON
SLAVES 1-4)
(TO USER PORT 2 ON
SLAVES 1-4)
USBVEXT-xx-MM
USBVEXT-xx-MM
USBVEXT-xx-MM
USBVEXT-xx-MM
(USER
PORT 1)
(USER
PORT 1)
(USER
PORT 1)
(USER
PORT 1)