Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
1-2 Introduction
v1.0, May 2007
• 1U chassis can be mounted in a standard 19-inch network equipment rack.
• The firmware can be easily upgraded as future software releases are made available. You can
install upgrades using HTTP.
Front and Rear View
The standard version of the WFS709TP ProSafe Smart Wireless Switch contains a 1000BASE-T
copper Gigabit Ethernet (GE) connector.
Figure 1-1 shows the front and rear views of the switch.
System Indicator LEDs
The system LEDs, located on the front of the switch, display the status of system power and
operation.
Figure 1-1
Table 1-1. System LEDs
LED State Description
Power Green WFS709TP is receiving proper power.
Off WFS709TP is powered off.
Status Green WFS709TP has booted and is functioning properly.
Off WFS709TP is booting, loading software, or has failed.
Note: This LED remains off until you perform the
initial setup described in the document Installation
Guide: WFS709TP ProSafe Smart Wireless Switch.
1