Filter
Top Products
110
SYMPTOM CHECKS REMEDY
Poor picture with RGB signal input. • Improper control setting. Incorrect 15 PIN connector pin
connections.
• Adjust picture controls as needed. Check pin assignments and
connections.
Tint is poor or colors are weak. • Are the tint and colors properly adjusted? • Adjust the tint and color (under PICTURE).
Nothing appears on screen. • Is the computer’s power turned on? • Turn on the computer’s power.
• Is a source connected? • Connect source to the monitor.
• Is the Auto Off function in the standby or off mode? • Operate the computer (move the mouse, etc.)
• Is LOOP OUT set to ON? • Set LOOP OUT OFF.
Part of picture is cut off or picture is not
centered.
• Is the position adjustment appropriate? • Adjust the IMAGE OPTIONS properly.
Image is too large or too small. • Is the screen size adjustment appropriate? • Press the ASPECT button on the remote control and adjust
properly.
Picture is unstable. • Is the computer’s resolution setting appropriate? • Set to the proper resolution.
POWER/STANDBY indicator is lighted
in red.
• Horizontal and / or vertical sync signal is not present when the
Auto Off control is on.
• Check the input signal.
POWER/STANDBY indicator is blinking
in red.
• The temperature inside the main unit has become too high and has
activated the monitor.
• Promptly switch off the power of the main unit and wait until the
internal temperature drops. See *1.
POWER/STANDBY indicator is blinking
in green and red, or green.
----------
• Promptly switch off the power of the main unit. See *2.
*1 Overheat Protector
If the monitor becomes too hot, the overheat protector will be activated and the monitor will be turned off. If this happens, turn off the power to the
monitor and unplug the power cord. If the room where the monitor is installed is particularly hot, move the monitor to a cooler location and wait for
the monitor to cool for 60 minutes. If the problem persists, contact your Vidikron Authorized Dealer.
*2 In the following case, power off the monitor immediately and contact your Vidikron Authorized Dealer or Vidikron Authorized Service Center. The
monitor turns off 5 seconds after powering on and then the POWER/STANDBY indicator blinks. It indicates that the power supply circuit, plasma
display panel or temperature sensor have been damaged.
Troubleshooting (continued)