Filter
Top Products
ViewSonic 41 PJ513D/PJ513DB
8. As shown in the figure, hold the new
lamp first and align the lamp with the
compartment in the projector, and
then insert the lamp all the way into
the projector.
9. Tighten the screw that secures the
lamp.
Loose screw may cause a bad
connection, which could result in
malfunction.
Do not over tighten the screw.
10. Connect the lamp connector to the
projector.
11. Place the lamp cords back to the slots.
12. Replace the lamp cover on the
projector.
13. Tighten the screws that secure the
lamp cover.
Loose screw may cause a bad
connection, which could result in
malfunction.
Do not over tighten the screws.
14. Restart the projector.
Do not turn the power on with the
lamp cover removed.
15. Resetting the lamp timer
Do not reset if the lamp is not
replaced as this could cause damage.
i. Go to the SYSTEM SETUP:
Advanced > Lamp Settings
menu. Press MODE/ENTER.
ii. The Lamp Settings page
displays. Highlight Reset Lamp
Timer.
iii. A warning message displays
asking if you want to reset the
lamp timer. Highlight Reset and
press MODE/ENTER. The lamp
time will be reset to '0'.
Reset lamp timer?
Reset
Cancel
Notice