Filter
Top Products
20
Operation
Powering On/Off the Projector
Powering On the Projector:
1. Complete the AC power cord and peripheral signal cable(s) connections.
2. Press to turn on the projector.
The projector takes a minute or so to warm up.
3. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source when Auto source setting is ON.
• If you are connecting multiple sources to the projector simultaneously, press
SOURCE on the projector to select your desired signal or press your desired
signal key on the remote control.
• If the projector doesn't detect a valid signal, the message 'No Signal' will con-
tinue to be displayed.
• Be sure the Quick Auto Search function in the SOURCE menu is On if you want
the projector to automatically search for the signals.
Warning
• Remove the lens cap first before powering on.
• Never look into the lens when the lamp is on. This can damage your eyes.
• This focal point concentrates high temperature. Do not place any object near it to avoid
possible fire hazard.
Powering Off the Projector:
1. Press to turn off the projector lamp. You will see a message "Power off? Press
Power again" appear on the screen.
2. Press again to confirm.
• When green mode is turned off, the Power LED begins flashing and the projec-
tor has entered stand-by mode.
• When green mode is turned on, the Power LED becomes steady light and the
projector has entered stand-by mode.
• If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-by
mode, simply press to restart the projector.
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off.