Filter
Top Products
28
Swap
Allow user to swap input source in PIP or POP image.
Green Mode
Enable this function when power consumption is under 0.5W.
Network
Wired LAN
Allow you to configure the wired LAN settings.
• Status: Display the projector’s status.
• DHCP: Abbreviation for Dynamic Host Configuration Protocol. This protocol
automatically assigns IP Address to networked devices.
• When the “DHCP” sets to “On”, it takes some time to obtain IP address from
DHCP server.
• When the "DHCP" sets to "Off", that means user will set IP address by manually.
• IP Address: Numerical address to identify networked computers. This function can
only be used when DHCP is set to Off.
• The IP Address is the number that identifies this projector on the network. You
cannot have two devices with the same IP Address on the same network.
• The IP Address “0.0.0.0” is prohibited.
• Subnet Mask: A numeric value to define the number of bits used for a network
address of a divided network (or subnet) in an IP Address. This function can only
be used when DHCP is set to Off.
• The Subnet Mask “0.0.0.0” is prohibited.
• Default Gateway: A server (or router) to communicate across networks (subnets)
that are divided by Subnet Mask. This function can only be used when DHCP is set
to Off.
• DNS: Setup DNS server address when DHCP is disable.
• Apply: Save and execute the wired LAN settings.
Wirless LAN
Allow you to configure the wireless LAN settings.
• Status: Display the projector’s status.
• SSID: Display the projector’s SSID information.
• IP Address: Numerical address to identify networked computers. This function can
only be used when DHCP is set to Off.
• The IP Address is the number that identifies this projector on the network. You
cannot have two devices with the same IP Address on the same network.
• The IP Address “0.0.0.0” is prohibited.
• Connection Mode: Methods for connecting to wireless networks with Wi-Fi enabled
devices.
Network Restart
Restore network settings to default.
The password for web administrator and vsPresenter will be reset to default “admin”.
Information