Filter
Top Products
38ViewSonic PJ656
Multifunctional settings
OPTION Menu
Item Description
AUTO SEARCH
Using the buttons ▲/▼ turns on/off the automatic signal search function.
TURN ON
TURN OFF
This function works with INPUT, RGB, and VIDEO buttons.
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in the following order. The search is
started from the current port. Then when an input is found, the
projector will stop searching and display the image.
RGB IN1
RGB IN2
COMPONENT VIDEO
S-VIDEO
VIDEO
•
When the RGB IN2/RGB OUT port functions as an RGB out port (the
RGB IN OUT switch is pushed in), RGB IN2 cannot be selected. In
that case “RGB2/RGB OUT
RGB OUT
”
message will be displayed.
AUTO OFF
Using the buttons ▲/▼ adjusts the time to count down to
automatically turn the projector off
.
Long (max. 99 minutes)
Short (min. 0 minute = DISABLE)
AUTO OFF
ENABL
E
1
AUTO OFF
DISABL
E
0
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with no-
signal or an unsuitable signal reaches at the set time, the projector
lamp will go off and the power indicator begins blinking. Please
refer to the section “Turning off the power”.
LAMP TIME
The lamp time is total lamp hours used after the last resetting of the
counter. It is shown in the OPTION menu as the usage time of the
lamp.
Pressing the RESET button on the remote control
or the button ►
of the projector displays a dialog. To reset the lamp time, select the
RESET using the button ▲.
RESET
CANCEL
• Please reset the lamp time only when you have replaced the lamp,
for a suitable indication about the lamp.
• For the lamp replacement, see the section "Lamp".
FILTER TIME
The filter time is the time counted after the last resetting. It is shown
in the OPTION menu as the usage time of the air filter.
Pressing the RESET button on the remote control or the button ► of the projector
displays a dialog. To reset the filter time, select the RESET using the button ▲.
RESET
CANCEL
•
Please reset the filter time only when you have cleaned or replaced
the air filter, for a suitable indication about the air filter.
• For the air filter cleaning, see the section "Air filter".
With the OPTION menu, the items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the projector or
remote control, and press the cursor button ► on the projector
or remote control, or the ENTER button on the remote control to
execute the item, except for the items LAMP TIME and FILTER
TIME. T
hen perform it referring to the following table.
MENU [RGB]
PICTURE
:SELECT
IMAGE
SETUP
INPUT
OPTION
EASY MENU
SCREEN
AUTO OFF 0min
LAMP TIME 0h
FILTER TIME 0h
AUTO SEARCH TURN OFF
SERVICE