ViewSonic Pro8500 40
Wireless connection
To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
1. Make sure the projector is turned on.
2. Press
MENU/EXIT
on the projector or
Menu
on the remote control and then press
/ until the
NetWork
menu is highlighted.
3. Highlight
Wireless LAN
and press
ENTER
on the projector or
Enter
on the
remote control.
4. Make sure the
Status
is
Connect
.
5. Make sure the
SSID
information is displayed.
6. Press to highlight
Connection Mode
and press / to select
AP
or
Infrastructure
. In
AP
mode, you need to use your computer’s wireless
connection utility to search the projector’s SSID and connect to it. Then you can
search the projector with pwPresenter. To use
Infrastructure
mode, you should
connect both your computer and projector to the same AP router and make
connections with the IP address.
Important
If you need more information about AP and Infrastructure modes, please
refer to user documentations for Wireless Routers which are usually
available on 3C stores.
ViewSonic
wireless dongle