Filter
Top Products
53
HDMI 1/HDMI 2: Enables or disables the HDMI 1 and HDMI 2 sources.
RGB: Enables or disables the RGB source.
Comp 1/Comp 2: Enables or disables the Component 1 and Component 2 sources.
Video: Enables or disables the Composite video source.
Note
If either Component 1 or Video is enabled, SCART must be disabled.
S-Video: Enables or disables the S-Video source.
SCART: Enables or disables the SCART RGBS source.
Note
If SCART is enabled, both Component 1 and Video must be disabled.
Auto Power Off: Set Auto Power Off to On to have the H9080FD turn itself off after 20 minutes of inactivity (no
source signal present).
Auto Power On: Set Auto Power On to On causes the projector to automatically power up when AC power is
present. If the projector is plugged into a switched AC outlet, this allows the projector to be turned on using a wall
switch instead of the remote control unit. If you do not need this capability, set Auto Power On to Off (this is the de-
fault setting).
Rear Projection: This control reverses all images and menus, and is necessary when the projector is used in rear-
projection applications. The default is Off.
Ceiling Mode: This control flips the image so the projector can be used in ceiling mounted installations.
Trigger-1: Select the primary screen trigger condition:
LED: Triggers the screen when the LED is turned on.
16:9, Letterbox, 4:3, or 4:3 Narrow: Triggers the screen when the selected aspect ratio is active.
RS232: Triggers the screen when the RS232 “Trigger On” command is received.
Trigger-2: Select the secondary screen trigger condition (see descriptions for Trigger 1).
Note
Trigger commands are deactivated when a PIP source is active.
Factory Reset: Select Factory Reset to restore all projector settings - except those listed
below - to their factory-default values:
LED Hours
Model Name / Serial Number
Language
User Memory 1 / User Memory 2
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
operaTion